Basic Mechanical Trainer Kit

Model - MECH01

Description

NiYo Engineers’ Basic Mechanical Trainer Kit is one of the most comprehensive training kit to impart hands-on training on pulleys, bearings, chain-sprockets, etc. The setup includes a Base Unit and four separate modules.

The Base Unit consists of,

  • Single-Phase 0.25 HP, 1440 RPM Motor
  • Adjustable Motor Base
    Manual Motor Starter
  • Switch with Lock-Out/Tag-Out
  • Aluminium Structure with Acrylic Cover with safety interlocks

The four Modules are,

  1. Pulley and Belt Drives Trainer Kit (Module)
  2. Chain and Sprocket Drives Trainer Kit (Module)
  3. Gears Trainer Kit (Module)
  4. Bearing Trainer Kit (Module)

Pulley and Belt Drives Trainer Kit

Pulley and Belt Drives Trainer Kit (Module) consists of Various types of V Belt, Flat Belt, End-less Belt, Variable Speed Belt, and Timing Belt, different types of pulleys suitable for the belts supplied, Variable Pulley Set, Pulley Idler, Taper Bush & Bolts, Shaft of different diameter, Pedestal Bearing. Various tools required for conducting hands-on training are supplied.

Topics covered are,

  • Identifying different types of belts and its applications.
  • Selection of Belt Drive: Calculation based on HP Transfer and Driven and drive speed.
  • Safety Procedure
  • Alignment of Belt
  • Belt Tightening and Removal
  • Check Shaft Run-out
  • Check Pulley Run out
  • Bushing Installation & Removal
  • Run-Out shaft
  • Run-out Pulley
  • Sheave and Belt Gauge

Chain and Sprocket Drives Trainer Kit

This Trainer Kit consists of Various types of chain, sprockets, Idler Sprocket, Chain Breaker, etc.

Topics covered are,

  • Identify Different Types of Chain
  • Application of Different Types of Chain
  • Selection of Chain Drive: Calculation based on HP Transfer and Driven and drive speed.
  • Safety Procedure
  • Alignment of Chain
  • Use of Idler sprocket
  • Tightening and Removal
  • Check Shaft Run-out
  • Check sprocket Run out
  • Bushing Installation & Removal

Gear Trainer Kit

Gear Trainer Kit (Module) consists of different types of gear, gear with different pitch, Shaft with pedestal bearing for each of above gear and different types of measuring instruments needed for gear parameters measurement

Topics covered are,

  • Identify Different Types of Gears
  • Teeth Description: Pitch, No. of teeth and diameter.
  • Backlash
  • Application Gears
  • Gear Ratio and rpm
  • Safety Procedure
  • Alignment of Gears
  • Use of Idler gear
  • Check Shaft Run-out
  • Check Gear Run-out

Bearing Trainer Kit

Bearing Trainer Kit consists of various types of bearings. Each bearing comes with its shaft and board mounting arrangement. Necessary basic tools needed for bearing mounting and removal are also supplied. For advanced practice, an advanced tool kit can also be supplied that incudes induction heater among other things.

Topics covered are,

  • Identify Different Types of Bearing
  • Identify Different Types of Bearing Housing
  • Bearing Tolerances: Shrink fit, slide fit and press fit
  • Safety Procedure
Get in touch today to discuss
your specific needs

Download Datasheet

    REQUEST INFORMATION

        Powered by
        Scroll to Top